This is our 1985 Chevrolet C/K 10 Stepside. We purchased the truck in 1990 with the intention of building a hot rod truck for my son. We did not achieve that goal until 2010. We began with the drivetrain. The motor was professionally rebuilt by engine pro. Bored 60 over, new crank, pistons and rings, new ported heads, Thumper cam, Edelbrock Performer Intake, Holley Carb, Hooker Headers and 3 inch exhaust and new radiator. The tranny is a built turbo 400 with a shift kit. The drivetrain includes a 3500 stall convertor and backed up with a 10 bolt posi rear end. The body was taken down to the frame. The front fenders, door skins, rear fenders, side and back bed panels and steal shaker hood were replaced with new. Genuine GM parts were used when available. All new glass and window gaskets. A new oak bed kit was used to replace the old bed and includes stainless steal hardware. The interior is all new. The Dash, carpet, seat, door panels, knobs are new. I installed a Rockford Stereo, Stinger T Block, Kicker Amp. and a Custom Autosound Classic Car AM/FM radio that includes a conversion kit that plugs into ipods, nanos, iphones and other electronic to listen to your favorite music. The grill, headlights, taillights bumpers and hardware has been replaced. The Hoses, belts, plug wires, alternator, power steering pump, water pump replaced as well. We lowered the truck 4 inches in the rear and 2.5 inches in the front. Replaced all the brakes and hoses. We replaced the gas tank and the truck includes a new gas tank gage. The final addition is a set of 15 x 6 inch weld wheels in the front and 15 x12 inch weld wheels in the rear. Mickey Thompson Drag Radials in the front and Hoosier Pro Stock Radials in the rear. This truck was a labor of love and the parts and paint alone exceed more than twice what it is listed for. All the documentation I have goes with the truck. Restoration pictures included with photos. This truck runs and drives like new! Thanks for Looking.